Outdoor power supply 1 1 degrees

What should the enclosure for outdoor EPSS equipment be capable of?

For EPSS equipment located outdoors, the EPS shall be located in a suitable enclosure located outside the building and capable of resisting the entrance of snow or rain at the maximum wind velocity as required by local building codes.

How do I connect a load to a power supply?

To connect a load to the power supply, use a wire diameter large enough to handle the maximum continuous output short-circuit current of the power supply without the wire overheating. Do not place heavy objects on the instrument. Do not obstruct cooling air flow to the instrument.

How do I program the power supply?

Users can program the power supply by using the SCPI (Standard Commands for Programmable Instruments) commands over the TTL remote interface (via USB virtual com with IT-E132B). Note: The RMT indicator will appear on display when the power supply is successfully connected to a PC remotely through any remote interface.

How do I access a power supply via a COM port?

It can be accessed and control via the assigned COM port (This can be verified in “Device Manager”) the same way as you would with RS-232 serial interfaces. In order for the computer to communicate with the power supply, both must be set to the same RS-232 settings.

How do I change the initial power-on state of a power supply?

The initial power-on state of the power supply outputs can be configured to either be off or to the last output state. From the MENU, navigate to OUt using the be selected by using the keys or rotary knob.

What type of power do I need for my instrument?

This instrument is intended to be powered from a CATEGORY II mains power environment. The mains power should be 120 V RMS or 240 V RMS. Use only the power cord supplied with the instrument and ensure it is appropriate for your country of use.